HSM 70.2 5,8mm Instrukcje Operacyjne Pobierz pdf (Strona 12)

12 Classic 70.2 • Primo 700 09/2011

english

6 Troubleshooting

Paper jam

You have fed in too much paper.

Notice Do not press rocker switch alter-

nately forwards/backwards (

 - 

). Cutting

unit could be damaged.

• Press rocker switch .

 Pa per is pus hed out.

• Se pa ra te pa per stack.

• Press rocker switch .

• Feed in pa per successively.

T

S

For all other malfunctions, check whether

the cutting head was correctly positioned on

the shredded material container before con-

tacting our customer service. If the motor

was overloaded, let the shredder cool down

for 15 to 20 minutes before using it again.

Shredded material container full

Notice Empty the cut material container,

immediately because if it is too full, malfunc-

tions can occur in the cutting system.

• Press automatic start stop control

for 2 sec.

• Switch equipment off. To do this

tap rocker switch .

• Move cutting head away.

• Empty cut material container.

• Remove cutting head.

T

7 Cleaning

WARNING

Dangerous mains voltage!

Switch off the shredder and pull

out the mains plug.

When cleaning only use a soft cloth and a

mild soap-water solution. However, no water

must enter the equipment.

8 Disposal / Recycling

Electrical and electronic old de-

vices contain a variety of valuable

materials, but also hazardous

substances which were required

for function and safety. Incorrect

disposal or handling can be dan-

gerous to your health and the environment.

Never dispose of old devices in the house-

hold waste. Observe the current applicable

regulations and use the collection points for

returning and recycling electric and elec-

tronic devices. Dispose of all the packaging

materials also in an environmentally-respon-

sible way.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Komentarze do niniejszej Instrukcji

Brak uwag